V2000-c Rfid Access Control User Manual [HOT]

Press * + 9999 + # . The LED indicator will flash slowly, indicating you are in programming mode.

You now hold the equivalent of an advanced training course for the . This user manual has walked you from the screw terminals of the relay to the logic of anti-passback and multi-card open. V2000-c Rfid Access Control User Manual

The V2000-c supports two adding methods: by card swipe or by manual ID entry. Press * + 9999 + #

Open Button (PUSH) – Connects to an exit button terminal; the other side of the button goes to GND. Purple: Bell+ (Doorbell interface) Blue: Bell- (Doorbell interface) Standard Wiring Layout This user manual has walked you from the

The V2000-C RFID access control system is designed to be easy to operate and maintain. Here are some tips on operating and maintaining the system:

To configure the unit, you must enter programming mode: * → [Master Code] → # (The yellow LED will light up, indicating you are in programming mode) . 4.2 Changing the Master Code Enter Programming Mode: * 123456 # Press 0 → [New 6-digit Master Code] → # Repeat [New 6-digit Master Code] → # Exit: * 4.3 Adding Users (Cards or PINs) Enter Programming Mode. Press 1 → [Read Cards] → # → * Add PIN Only: Enter Programming Mode. Press 1 → [Enter 4-6 digit PIN] → # → * 4.4 Deleting Users Delete a Card: Enter Programming Mode. Press 2 → [Read Card] → # → * Delete by PIN: Enter Programming Mode. Press 2 → [Enter PIN] → # → * 4.5 Setting Door Relay Time To adjust how long the door stays unlocked: Enter Programming Mode. Press 4 → [0-99 seconds] → # → * 5. Troubleshooting & Tips

The device automatically assigns the next available User ID slot.