Ts1162 Installation Manual Exclusive !exclusive! 🔖

This guide is for informational purposes only. Always consult the official provided by the manufacturer. Failure to do so may void the warranty or result in damage.

The TS1162 features dual-ported 16 Gb Fibre Channel (FC) interfaces for high-availability host connections and multipathing capabilities.

Separate the body from the base by removing the retaining screws at the bottom.

: Wire a standard normally-open (NO) exit button to the dedicated RTE input loop on the cable. ts1162 installation manual exclusive

Under bright white light (minimum 500 lumens), inspect the housing of the TS1162. Look for:

Mounting the TS1162

Once the panel discovers the TS1162, you must configure its behavior (e.g., whether it acts as an arming station, controls a door, or is purely informational). Access the menu. Assign the specific Area Number this RAS will control. This guide is for informational purposes only

CHALLENGER PANEL RS-485 LAN TERMINALS ┌───────┐ ┌───────┐ ┌───────┐ ┌───────┐ │ +12V │ │ GND │ │ D+ │ │ D- │ └───┬───┘ └───┬───┘ └───┬───┘ └───┬───┘ │ │ │ │ │ (Red) │ (Black) │ (White) │ (Green) │ │ │ │ ┌───┴───┐ ┌───┴───┐ ┌───┴───┐ ┌───┴───┐ │ +12V │ │ GND │ │ D+ │ │ D- │ └───────┘ └───────┘ └───────┘ └───────┘ TS1162 KEYPAD LAN TERMINAL BLOCK RS-485 LAN Bus Connections

Position the bracket against the surface. Use a leveling tool to ensure it sits perfectly horizontal. Mark the pilot holes, drill into the structural supports, and secure the bracket tightly using the heavy-duty screws provided in the hardware kit. Step 3: Mounting the TS1162 Unit

: Three status LEDs provide clear system arming and area status information. Step 1: Pre-Installation Requirements The TS1162 features dual-ported 16 Gb Fibre Channel

Log in using the administrator credentials listed in your factory package.

Full installation and programming manuals for the Challenger ecosystem are available to authorized technicians on the Aritech Support Portal .

Connect a standard, normally open (NO) momentary button across the dedicated RTE input terminal and the local common ground loop. When closed, this signals the main controller to temporarily bypass the door position sensor and trigger the strike relay. Open Collector Door Control