: Always park the lift on a charging contact to prevent battery drainage. If the lift emits a continuous audio signal, it may not be charging correctly. Clearing Obstacles
The carriage contains the motor, gearbox, electronic control board, and safety brake (governor).
The full is not publicly available. Certified installers can access the latest revision via the ThyssenKrupp Access Dealer Portal after passing annual recertification. Updates typically address rail material tolerances (since 2021 models use extruded 6063-T5 aluminum) and software flashing procedures for the Levant’s CAN-bus controller.
The Levant runs on a 24V DC battery system that constantly recharges when parked at the top or bottom stations. Step 1: Connect Internal Batteries thyssenkrupp levant stair lift installation manual full
Do not fasten the brackets to the stairs yet; allow the rail assembly to rest freely on the step noses. Step 3: Setting the Charging Strips
Installing a stair lift involves structural work and electrical connections. Thyssenkrupp highly recommends that the Levant be installed by a certified professional to ensure safety and maintain warranty coverage. 1. Pre-Installation: Site Survey and Preparation
Pull the electrical wiring through the rail during assembly to connect charging points. : Always park the lift on a charging
Professional installation is typically recommended, but general steps for this model include: Track Pre-assembly
Explain the to keep your Levant running smoothly ThyssenKrupp Homeglide Striaght Stairlift Manual
Distance from the top chassis to the nearest obstruction when parked. 0.75 inches (20 mm) The full is not publicly available
| Test | Procedure | Pass/Fail | |------|-----------|------------| | Obstruction | Place a 2x4 on the stair. Lift must stop on contact. | ____ | | Overload | Apply 150 kg (331 lbs). Lift should stall and beep. | ____ | | Seat belt | Pull sharply—must lock. | ____ | | Parking | Fold seat fully. Unit must fit within 10" of wall. | ____ | | Remote | Range test: 15 meters (50 ft) through one wall. | ____ | | Manual lowering | Insert release key, turn 90°. Lift descends at 0.2 m/s. | ____ |
Battery-operated drill, impact driver, and a socket set (7mm to 19mm).