Ericsson Mini Link Cli Commands ◎

: Connect via SSH and use show version and show interfaces to verify the node is running the correct software and the physical ports are recognized.

: Displays the active VLAN database, showing VLAN IDs and associated switch ports.

Access to the CLI is typically gained through a terminal emulator via Telnet, SSH, or a direct serial connection to the NPU unit. Default Password: Enable Privileged Mode: > enable Password: ericsson Use code with caution. Copied to clipboard Unlock Hidden Commands: (Use with caution for advanced debugging) # cliunlock Use code with caution. Copied to clipboard Essential CLI Commands Command Category Description System Info show board Displays serial, type, and software version of all boards show board 1/2 config ericsson mini link cli commands

These commands control the high-frequency radio frequency (RF) parameters, transmitter states, and alignment diagnostics.

Configuring and maintaining the microwave hop is the core responsibility of a transport engineer. Use these commands to manage radio frequency (RF) parameters. Radio Terminal Status : Connect via SSH and use show version

To see past alarms that have been cleared:

show radio : Summarizes the status of all connected Radio Units (RAU), displaying frequency, actual output power, and link state. Default Password: Enable Privileged Mode: > enable Password:

The default IP address and credentials vary depending on the hardware generation (e.g., MINI-LINK TN, PT, or 6000 series).

pm -show -interval 15min : He pulled the performance monitoring data. For a moment, the errors dropped. ping 10.1.1.1 : He sent a pulse across the microwave hop. Request timed out. Request timed out.

GET AL