If you are an audio engineer or a live sound enthusiast, you likely know that the dbx DriveRack 260
uses an RS-232 serial port (DB9) for firmware updates. You will likely need an RS-232 to USB converter.
: Full support for DriveWare v2.6.2 (Windows) , the control software used for PC-based management. How to Verify Your Version To see if your unit is running v1.61: Turn off the DriveRack 260. Watch the LCD Display while powering the unit back on. driverack 260 updater v161 updated
After the update, users report:
Since its release, v1.6.1 has been widely adopted by rental houses and installers. If you are an audio engineer or a
Because this is legacy software, you will not find it on the official Harman site (they redirect to the VENU360). However, the version lives in community archives.
Attach the RS-232 cable to the back of the DriveRack 260 and your PC. How to Verify Your Version To see if your unit is running v1
Newer production runs of the DriveRack 260 feature updated internal microcontroller units (MCUs). These newer units ship from the factory with v1.61 firmware pre-installed.
A: Yes. The "M" version uses identical DSP firmware. However, the front panel LEDs will not change behavior.
: A failed update can leave the unit in a "bootloader" state—essentially a blank screen. This often requires a Hard Reset (holding the STORE button during power-up) or a specific "Blind Update" procedure to bring the unit back to life.
This article serves as the definitive guide to the DBX DriveRack 260 v1.61 firmware update. Whether you are experiencing system sluggishness or simply want to ensure your unit is running the most current software, this guide will provide a step-by-step update procedure and explain why this version is so important.