The satellite receiver is turned off, or the cables are reversed.
Attenuates (reduces) high signal levels to help isolate the exact peak of a satellite beam. 2. Technical Specifications Specification Frequency Range 950 MHz – 2150 MHz Input Level Range -40 dBm to -10 dBm Impedance Insertion Loss ≤ 5.0 dB Operating Voltage DC 13 V – 18 V (supplied by receiver) Connectors F-Type Female (Input / Output) 3. Port Configuration & Controls
When the meter reading rises and the audio tone becomes high-pitched, you have located a satellite. Gently adjust the dish elevation (up and down) and azimuth (left to right) until you find the highest possible number on the screen. Step 5: Attenuate and Fine-Tune deutsche technologies rv3 digital satellite finder manual
If you are a caravanner, boater, or RV enthusiast, you know the frustration of arriving at a beautiful remote campsite, setting up your outdoor chairs, and then spending the next hour aimlessly waving a satellite dish around the sky hoping for a signal.
Connect a coaxial cable from the on your dish to the "To LNB" port on the RV3. The satellite receiver is turned off, or the
Go indoors and plug in the satellite receiver. Turn the receiver power switch ON.
If the meter hits 99% or maxes out, turn the DB knob down to lower the reading back to 50%–60%. Continue micro-adjusting the dish to find the true peak center of the beam. Step 5: Attenuate and Fine-Tune If you are
: Adjust the level control or attenuation to reduce the reading to roughly 5, then move the dish in small increments to find the maximum possible signal level 5. Technical Specifications Typical metrics for these digital units include: Digital Satellite Finder Guide | PDF - Scribd
: Includes a step-by-step guide to the "Find Satellite," "List Satellite," and "Edit Satellite/Transponder" menus. Visual Alignment
The Deutsche Technologies RV3 is a high-accuracy, microprocessor-controlled digital satellite signal meter designed for reliability and ease of use.
Disclaimer: As of this writing, Deutsche Technologies has been absorbed into a larger European test equipment group. If the official site is down, archive.org may have a cached copy.