Sarah then activated the showerhead by pressing the button on the handle. The V200's showerhead sprang to life, delivering a soothing spray of water that covered her entire body. She loved the wide coverage area of the showerhead, which made her feel like she was showering under a mini-massage.
Caraflo V200 is a thermostatic shower mixer valve commonly used in static caravans and holiday homes. Below are instructions for its installation, use, and winter maintenance. Installation Instructions caraflo v200 shower instructions
| | Possible Cause | Suggested Remedy | |-------------|--------------------|----------------------| | No water flow | Inlet supplies reversed (hot on cold, cold on hot) | Check and correct pipe connections | | | Filters or strainers blocked | Clean the filters (see “Maintenance” section) | | | No hot water reaching the mixer | Check water heater operation | | | Water supply isolated | Ensure mains feed taps are fully open | | Low or fluctuating flow | Kinked or damaged shower hose | Inspect and replace hose if necessary | | | Blocked filters | Clean the inlet filters as described above | | | Low system pressure | Verify pressure meets requirements (see below) | | Temperature too hot | Cold water supply failure (fail‑safe should shut off) | Immediately turn off flow . Check cold supply. If problem persists, replace thermostatic cartridge. | | | Thermostat incorrectly adjusted | Adjust internal temperature setting | | | Hot water supply exceeds 65°C | Check water heater settings – maximum allowed is 65°C | | Temperature too cold | Hot water supply too low (below 55°C) | Check water heater – minimum required is 55°C | | | Thermostat incorrectly adjusted | Adjust internal temperature setting | | | Pressure imbalance between hot and cold supplies | Install pressure balancing device or check system design | | Leak from the valve body | Worn O‑rings or seals | Replace damaged seals. Use genuine Caraflo parts. | | | Mixer not tightly seated on tails | Remove, clean, and re‑tighten grub screws | | Leak from shower head connection | Loose or damaged hose washer | Replace the washer or tighten the connection | | Water runs cold when flow is turned back on during shower | Normal thermostatic behaviour | Allow a few seconds for the valve to recover to set temperature | | | Thermostatic cartridge sluggish | Consider replacing the cartridge | Sarah then activated the showerhead by pressing the
Are you experiencing issues with water pressure consistency while , or are you currently planning a complete bathroom renovation for your campervan? Share public link Caraflo V200 is a thermostatic shower mixer valve
: A button on the temperature handle prevents accidental setting to excessively high temperatures; it must be pressed to override this limit for hotter water. Water Requirements : Hot Supply : Recommended between 55°C and 65°C. Cold Supply : Should be less than 25°C. Operating Pressure : Designed for 0.5 to 5 bar.
Screw the shower hose onto the central shower outlet. Use a washer to prevent leaks.
Turn off the water supply to the shower unit.