Atir Strap And Beamd With 72 Install (PLUS)

: By pulling results directly from the STRAP post-processor , it eliminates the human error often found in manual data transfer between analysis and drafting. Optimizing the Install and Setup Process

This is almost always a user error. Ensure the .apf file has been downloaded to a known location on your computer (e.g., your Downloads folder) and that it is the correct file for your license. Do not rename the file. atir strap and beamd with 72 install

STRAP Software FAQ | Common Questions About Structural Analysis : By pulling results directly from the STRAP

If using SDS screws, torque to manufacturer spec (typically 90-110 in-lbs). Check that no gap exists between the strap and wood. A gap of more than 1/32” voids the load rating. Do not rename the file

When using power impact drivers, be careful not to "dimple" the strap. Over-driving fasteners can micro-crack the steel, leading to premature failure under stress.

: Transfer results to BeamD for reinforcement calculation and generation of production drawings.

: Choose the destination folder on your drive and click "Install".